How Products Are Made How Products Are Made

 
 FAQFAQ   SearchSearch   MemberlistMemberlist   UsergroupsUsergroups   RegisterRegister 
 ProfileProfile   Log in to check your private messagesLog in to check your private messages   Log inLog in 

Locating a manufacturer

 
Post new topic   Reply to topic    How Products Are Made -> How Products Are Made Forum
Author Message
shellm
Guest
PostPosted: Tue Jul 24, 2007 10:44 pm    Post subject: Locating a manufacturer Reply with quote
Hi does anyone know who to contact to help make a proto type of an action figure?
Back to top
dgelsen111
Guest
PostPosted: Tue Jan 08, 2008 1:07 am    Post subject: prototype action figure Reply with quote
this is very old....however... best bet. Locate a plastic's injection molder in your area. They will quote you on a mold (die). Most likely an aluminum mold for initial low cost. You do, however, need to have a large order for the action figure..like 5-10,000 pcs to make the run worth while for both parties.
Back to top
Display posts from previous:   
Post new topic   Reply to topic    How Products Are Made -> How Products Are Made Forum All times are GMT - 6 Hours
Page 1 of 1

 


Powered by phpBB © 2001, 2005 phpBB Group