How Products Are Made

Forum

Made How » Forum

Locating a manufacturer

Locating a manufacturer

Postby shellm » 24 Jul 2007, 22:44

Hi does anyone know who to contact to help make a proto type of an action figure?
shellm
 

prototype action figure

Postby dgelsen111 » 08 Jan 2008, 01:07

this is very old....however... best bet. Locate a plastic's injection molder in your area. They will quote you on a mold (die). Most likely an aluminum mold for initial low cost. You do, however, need to have a large order for the action figure..like 5-10,000 pcs to make the run worth while for both parties.
dgelsen111
 


Return to How Products Are Made Forum